pad

Click to enlargepadFilters Out the Deadly MTBE,
Fluoride, Lead and Arsenic

MTBE (Methyl-tertiary-butyl-ether) is the most common oxygenated fuel additive used in reformulated gasoline. Contamination of groundwater with MTBE is a rapidly growing problem in 49 U.S. states. In drinking water, even trace amounts of MTBE can cause taste and odor problems, which may lead to nausea and dizziness. The potential long-term health effects of MTBE are not understood at this time, however, initial studies indicate MTBE may cause kidney and liver problems. MTBE removal from water is a challenge because it is very soluble in water and must compete with other organics for binding sites on the filter medium. These other contaminants (BTEX - butane toluene ethylene xylene and TOC - total organic carbons) are adsorbed more readily, and MTBE often slips by standard carbon filters, ending up in the filtered water. The PF-4 filter has been specifically designed to remove MTBE from drinking water when used in conjunction with a British Berkefeld gravity filter system. The media within the Super Sterasyl filters, in the upper chamber, capture the more strongly adsorbed BTEX and TOC's. This permits the downstream PF-4, secured as a post filter, to more efficiently remove MTBE.

The PF-4 filter is manufactured to exceed ANSI/NSF Standard 53 which requires that MTBE be reduced by at least two thirds from an influent rate (water going in) of 15ppb to an effluent rate (water going out) of less than 5ppb. *The reduction efficiency of the PF-4 filter is greater than 95% and each four-oz. cartridge, of the four cartridge set, has an approximate capacity of 1,200 gallons even if contamination level is as high as 600ppb! MTBE removal is achieved via a special medium called "AquaBond". Its unique pore structure, created using a proprietary process, is designed for increased adsorption capacity for trace organics and weakly adsorbed species, such as MTBE, DBCP, THM's, pesticides and herbicides. The "AquaBond" granular medium has proven superior adsorption capacity compared to standard activated coal-based carbon. Generally, the longer the contaminated water is in contact with the effective medium, the greater the removal of MTBE. This is known as the "Trickle Method". Because the PF-4 filters used in conjunction with a British Berkefeld gravity filter incorporate the "Trickle Method", it is the preferred system for removing MTBE from contaminated drinking water sources. LEAD: Tests have shown that when 2000 gallons of influent water at a concentration of lead of 150-200 ppb pass through 200 grams of media at a flow rate of 1gpm, the lead level was reduced to less than 1ppb (>99% reduction). FLOURIDE: Testing for fluoride was based on 20-30ppm of the ion in the influent aqueous solution at a flow rate of no more than 3 gpm per cubic foot of media. Results of < 1ppm of the fluoride ion in the effluent were typical for the media (>95% reduction). Under optimum conditions, effluent concentrations of less than 50 ppb were readily achieved (>99.75% reduction)

-------------------------------------------------------------------------------- INSTALLATION INSTRUCTIONS:

No Tools Required

The PF-4 filters are used along with the Supersterasyl Ceramic water filters for the Berkefeld systems. Assemble the ceramic water filter as per the water filter assembly instruction. On the underside of the upper chamber locate the stem of each ceramic filter (do not remove the wing nut holding the ceramic filter in place). With clean hands, remove blue caps and screw a PF-4 filter onto each filter stem (the blue arrow should point away from upper chamber) giving five full turns. Do not screw more than five turns as this may damage the internal media screen. When complete, seat upper chamber on top of the lower chamber. Fill upper reservoir. When the lower reservoir is full, discard the first batch of water, which may contain process dust. (Note: when lower chamber is full of water, the PF-4 filters will be immersed).

SIZE: 6" COLOR: WHITE MEDIA: 100 GRAMS OF MTBE - ADSORBING AQUABOND MEDIUM PER FILTER REPLACEMENT: *6 MONTHS OR 1,200 GALLONS (PER FILTER) MSRP: $93.00 PER SET OF FOUR -------------------------------------------------------------------------------- * Actual capacity is dependent on the presence of other competing contaminants in the source water. High levels of total organic carbons and volatile organic compounds may reduce the capacity and efficiency of these elements.


PF-4 Filter WA2057padQuantity: 
Join Our Mailing List Today!

Do you like this website? Why not tell a friend? Click here to recommend it!
If you like this survival website, please recommend it to a friend. You could save a life. Click here.

Search our site:

Click Below To Go To Desired Section
Home | Water Filters | Meals Ready To Eat
| AlpineAire Gourmet Reserves
Self-Defense | CD's, Books, & Videos
First Aid Kits | Camping & Survival Gear
Affiliate Program | Membership Program
Fax/Mail Order Forms | Catalog Requests

    Online and Faxed Orders are taken 24 hours a day, 7 days a week:

  • To place your order through the Internet, please select the product/s and add to the shopping basket.
  • Fax us your completed Order Form at 1(972) 937-6385
  • ©1999 - 2007 Survival Instinct. All rights reserved. Use of this site is subject to certain terms of use which constitute a legal agreement between you and Survival Instinct, LTD.